Garage Door Parts Home Bearings Bearing Plates Bottom Brackets Bottom Seals Brush Seals Cable Drums Cables Center Support Chain Hoists Door Butler Emergency Release Exhaust Ports Fasteners Hinges Door Insulation Keyless Entry Lift Handles Lock Handles Lubricant One Piece Hardware Operator Brackets Operator Parts Parking Wedges Pest Control Pulleys / Sheaves Radio Controls Rollers Rubber Astragal Safety Reverse Shafts Sliding Hardware Solenoid Lock Spring Fittings Springs Stop Moulding Struts Top Roller Carriers Track Degreaser Tracks Truck/Trailer Doors Vee Belts Vinyl Strip Doors Contact Us Shipping Return Policy Site Map View Shopping Cart

Genie^® Keyless Entry System

Works on any garage door opener
Secure - 214 million code combinations
Easy to install and program
Remembers code after power outage

Programming a KEP-1 Hardwired Keypad

To reprogram your KEP-1:

Unplug the transformer for 2 minutes, this will reset the board and erase old code.
Place the set / run switch to SET (found inside main interface box)
Chose your pin number (1 to 8 numbers or letters). Do not use the * in your pin. Enter chosen pin.
Press * button once to lock in pin number.
Move the set / run switch to RUN. Programming is complete.

Note: The Genie KEP-1 keypad set will remember a code for 30 seconds and will activate at the touch of any button. This is a "panic" feature for safety in case the unit is activated and someone (or something) gets in the path of the door.

Garage Door Parts Home

Genie® Keyless Entry System

Genie^® Keyless Entry System